Connectors for Sports Flooring

Connectors for sports flooring: Easy installation for modular systems

Our connectors allow sports flooring panels to be mechanically joined together. They provide additional stability, especially for exposed training areas or when the flooring is not to be glued down.

If the sports flooring is installed across the entire surface up to all four walls, connectors or adhesive are often not necessary. For maximum adhesion in professional settings, the flooring can alternatively be installed using PU rubber flooring adhesive.

The connectors are compatible with our sports flooring starting at 1.0 cm thick and are suitable for both home gyms and professional training areas.

How do I install the connectors?

1. Place the first sports floor panel on the floor.
2. Place the connector under the plate so that about half of it sticks out and the prongs are facing upward.
3. Tap the sports floor panel with a hammer or rubber mallet to secure it in the teeth:
   
   
4. Repeat the process for the remaining connectors.
5. Lay down the next sports floor panel and snap it into the connectors as well.

How many do I need?

Allow for the following number of connectors per linear meter of joint (between two panels).

• Home Gym Use: 2 pieces per running meter of joint
• Professional use / heavy-duty: 3 pieces per running meter of joint

Calculate your needs:
Measure or estimate the total length of all the gaps between the panels (in meters) and multiply this by 2 (for a home gym) or by 3 (for professional use).

Example: For a training area with 9 m² of sports flooring (3 x 3 panels), there will be a total of approximately 12 meters of joint length between the panels.

• Home Gym Use: approx. 24 connectors
• Professional use: approx. 36 connectors